Table of Contents
If you are installing a new garage door in Indianapolis, you should look into hiring a professional as well.
The task is very dangerous.
Hence, without proper training, the job could end up badly.
As a guide, here are the steps that a garage door installation in Indianapolis should follow:
Let go of the door’s tension.
The first step that you have to do is to release the tension of the garage door.
You will need extreme caution, as the springs of the garage door are under a huge amount of weight as well as tension.
If you handle it improperly, it may cause injuries as well as damages.
Hence, before you work on the installation, you should release the tension first from the torsion springs.
Disconnect the opener.
In installing a new garage door in Baltimore, it is necessary that you unplug the opener after you have secured the release of the tension from the springs.
In order to safely unplug it, all you need to do is pull the red emergency cord.
This action will move the arm of the trolley vertically so that you can raise or lower the door using your bare hands.
After this has been done, you can now begin the removal of the sectional door panels.
Start installing the panels.
When you are done making sure that the above-mentioned steps have been completed, you can now start the installation of the new garage door.
If you are replacing a garage door with two cars, then you should place a reinforcing bar at the top panel so as to prevent any bowing that is in the center.
Afterwards, you can drill the pilot holes if it has not been drilled by the manufacturer itself.
Then, simply utilize the screws in order to have the bar secured to the panel.
Fasten the hinges and install the tracks.
The next thing to do is to secure the top of each of the hinges on top of the top panel.
Then, put the wheel axles on the hinges from both sides.
After that, you can then install the top as well as the bottom axle supports.
Next, have the track installed and make sure that the wheels all lie rightfully in the track so as to make sure that it has proper functionality.
Lastly, simply attach the cable of the door to the hook that is found on the panel axle support that you can locate at the bottom.
Then, put the bottom bracket against the wall.
Attach the spring.
For this step, you should assemble the pieces that will support the spring and affix it to the track.
Afterward, use the ceiling from the support of the previous door.
Then, rest the section of the track that is curved on the vertical piece that has been made earlier.
Then, fasten the other rear to the bracket at the ceiling.
Secure the tracks together.
This step will require you to align the horizontal and vertical tracks.
You need to affix these tracks to the door and bolt them together.
Place the springs.
In installing a new garage door in Indianapolis, the next step is to link the spring anchors to the springs and affix a locking cone on them.
After that, you need to fasten them securely to the header bracket.
Affix the torsion rod and pulleys.
In order to install the torsion rod, simply slide it onto the holes that can be found on the side of the header brackets.
Then, just affix the pulleys to both ends of the rod.
If you are done, attach the cable and then tighten the springs as well.
Remember that you need to employ a garage door installation in Indianapolis to ensure safety.
Call Naptown Garage Doors
If you are installing a new garage door in Indianapolis, you have come to the right place.
Naptown Garage Doors is the perfect garage door company for you.
We are a team of professionals who offer garage door repair in Indianapolis as well as garage door installation in Indianapolis.
We guarantee a service that has been proven and tested by our previous customers.
Furthermore, we only offer satisfaction and quality services to every customer out there.
Do not stress about it!
In installing a new garage door in Indianapolis, contact Naptown Garage Doors.
Call us now!
