Table of Contents
Not knowing how to adjust garage door tracks is pretty normal.
After all, we are just homeowners.
Thankfully though, there are guides on the internet that can lend us a hand in getting to know our garage door.
Moreover, they can give us information on how to fix them.
Garage doors can easily close and open through lifting up as well as down, and it is made easier by the tracks.
There are rollers in the garage door that permit them to do this.
The tracks are located from the ground up until the ceiling.
They can also be found on both sides of the entrance, with an individual track on them.
The tracks are placed there to assist the garage door in its smooth operation.
Yet, they can loosen over time, which is uncomfortable.
Furthermore, if the tracks are out of alignment, other issues could arise.
These issues include the binding of the door, the rubbing against the molding, and the opening of a gap.
A misaligned track, however, is nothing to panic about.
It can be solved by a garage door repair in Indianapolis.
While we recommend leaving the job to the professionals, you can also do it on your own if you have the necessary tools, knowledge, as well as experience.
As such, here are some of the steps that you should take in how to adjust garage door tracks effectively:
Unfasten the track screws.
Make sure that the garage door is properly secured in the tracks first.
Then, have the screws loosened with the assistance of a screwdriver, which will have the tracks binded in the frame.
Make adjustments to the door’s position.
By means of a rubber mallet, tap the end of the track and ensure that it is in a vertical position.
To ensure effectiveness, make use of a spirit level to have the perfect alignment of the tracks confirmed.
Secure the screws.
Once you have confirmed that the track is now on the correct alignment, just fasten the screws to make sure that the tracks won’t move.
Make adjustments to the other track.
Once you have had the other track adjusted, you’ll need to move on to the other one.
Just make use of the rubber mallet once again and tap the end of the track.
Make sure that it is aligned straight.
Afterward, fasten the screws.
Using these four steps, you can easily know how to adjust garage door tracks by yourself.
However, keep in mind that if you are not confident, call for a garage door repair in Indianapolis immediately.
However, if you have tracks that are rubbing against the rubber molding, or else a gap is noticeable between them, then you can follow the steps below:
Have the bolts loosened.
The first thing that you need to do is to have the bolts loosened, which secures the tracks to the track bracket by means of a wrench.
Before you move on to the other steps, you have to verify first if the bolts on both tracks have been loosened.
Make adjustments to the gap.
Simply place one of the tracks left or right until a gap is left of about one-fourth inch, which is between the stop molding as well as the gap.
Keep in mind that the gap should be similar.
Do the same for the other track on the opposite side.
Secure the bolts.
Finally, have the track bolts tighten by means of a wrench.
Verify first that they have been tightened well.
However, you must avoid having them overtightened.
Call Naptown Garage Doors
If you are looking for answers on how to adjust garage door tracks, you have come to the right place.
Naptown Garage Doors is the perfect garage door company for you.
We are a team of professionals who offer garage door repair in Indianapolis as well as garage door installation in Indianapolis.
We guarantee a service that has been proven and tested by our previous customers.
Furthermore, we only offer satisfaction and quality services to every customer out there.
Do not stress about it!
In how to adjust garage door tracks, contact Naptown Garage Doors.
Call us now!